Application and network controls
Configure application access and incoming or outgoing connection rules.
Choose the policy scope
Section titled “Choose the policy scope”Open Policies, select a group and review its Base policy. Changes to the Default group can affect groups that inherit its settings. Use the application rules section for application-specific requirements.
Set connection boundaries
Section titled “Set connection boundaries”Review Default Network Action, Outgoing Rules and Incoming Rules. Additional controls can block Internet, LAN, device-local, inbound or direct connections. Check the effect on required services before enabling a broad block.
In each rule row, choose Allow or Block, then enter the destination without a + or - prefix. The editor supplies the action. Use the row controls to change rule order; the first matching rule applies unless an overriding Force Block setting takes priority.
A target can be a domain, address, network range, network scope, country, network operator or filter-list identifier. An optional protocol and port narrows the match. For example:
| Action | Target | Effect |
|---|---|---|
| Allow | example.com TCP/443 |
Permit HTTPS to this domain when the rule applies. |
| Block | Internet TCP/25 |
Block Internet SMTP connections on port 25. |
For incoming rules, the port is the endpoint’s listening port. For outgoing rules, it is the remote destination port. Test the result alongside the other applicable controls.
Review and publish
Section titled “Review and publish”Open Review & publish, inspect the changes and publish the policy. Confirm the affected device is online and shows the policy as synchronized.
Validate the application
Section titled “Validate the application”Test the required connection and a connection that should be blocked. Use application activity and endpoint history to inspect the recorded destination, decision and reason. For a device application exception, choose Allow, Block or Use group rule. Mandatory group domain blocks remain enforced.